Shop Jig Normally You Flatten A Face And The Edges Of A Board On A Jointer And Flatten The Opposite Face With A Thickness Planer You Then Square The Ends On The Table Saw Or Perhaps With A Miter Saw Regardless Of Your Method The Edges And Ends Of The Board Will More Than Likely Show Milling Marks Those Tiny Concave Cuts Made By The Jointer And Planer Knives
Shop jig normally you flatten a face and the edges of a board on a jointer and flatten the opposite face with a thickness planer you then square the ends on the table saw or perhaps with a miter saw regardless of your method the edges and ends of the board will more than likely show milling marks those tiny concave cuts made by the jointer and planer knives is article about Magazine bookmarked by shane with ID 12923319448 was uploaded on 25-01-2019 and has been viewed 267,460 times.
Shooting Board Illustration by James Provost SUPPLY CHECKLIST3/4" ply1/4" plyscrap hardwood2 cam clamps (optional) Sanding is one way to remove these marks, but you risk rounding over those crisp edges.
Another way is to work the edges with a card scraper -a bit of a nuisance, particularly on a long board, or half a dozen of them.However, with a well-tuned hand plane and a shooting board you can quickly and accurately true and smooth the edges and ends of boards.
Shooting boards come in various sizes.In many shops you will find two: a long shooting board for edge grain, and a shorter version for trimming end grain.Making the JigMake this jig from almost any sheet goods, or from solid wood.
At minimum you need a base, a sub-base, and a stop block.Melamine is a good base because it's smooth and the hand plane will glide across it.The sub-base need only be about ¼" to 5/16" thick - the width of the offset of the blade in the hand plane you are using (it can vary from plane to plane, so select the plane you will use with the shooting board before you build it).
A stop block keeps your stock...